The Frame Thang! Part 2

Good Afternoon Everyone!

Hope everyone is having an awesome Thursday!  As promised, here is part 2 of The Frame Thang that we finished up on Tuesday's Take Out Tuesday's Ustream Show....

Here's how the back of The Frame Thang turned out...

Add 3 Idea-ology Hinge Clips across the top about 1-inch down. (I glued these on.)

Cut (3) pieces of patterned paper covered chipboard to 3-1/2 x 4-inches.  Place these pieces on the clips centered.

Add (2) Idea-ology Ring Binders down from the top 6-inches and over from the left/right 3/4-inch. (I glued these on.)

Cut (2) pieces of patterned paper covered chipboard to 5-1/4 x 5-1/4-inches.  

For these covered pieces, come down 1/2-inch from the top edge and punch 1/8-inch holes at 1-1/8 and 4-1/4-inches.

Add the pieces cut above to the ring binders.

For decoration, cut (2) 1-1/2 x 10-inch pieces from chipboard and cover with patterned paper.  I used the We R Memory Keepers Stub cut Corner Chomper on all four corners.  

Apply the decorative pieces to each side.

Add (2) more Idea-ology Hinge Clips to the top of the decorative pieces.

Last, add a handle or knob to the top centered.

DONE!!!

Hope you give this project a try!

Thanks Tons!

Jim

The Gentleman Crafter

Pin It